There’s something about plumbing that just screams DIY. Whether it’s fixing a leaky faucet or installing a new water heater, the appeal of doing it yourself is undeniable. And there’s no better time to get started than now—with all the latest plumbing trends and innovations on the market, there’s never been a better time to learn how to do it yourself. In this blog post, we will teach you how to plumbing a vent using a tee fitting. By following these simple steps, you can easily fix a common plumbing issue in your house.

What is a Tee Fitting?

A tee fitting is a plumbing tool that allows you to connect two pieces of piping without having to create a new joint. To use a tee fitting, first make sure the pipes are the correct size. You’ll need to cut the tee fitting to the correct length, and then screw sanitary tee fitting  it onto one end of the shorter pipe and onto the other end of the longer pipe. Finally, use a wrench to tighten the fit.

How to Plumb a Vent with a Tee Fitting

Before you start, be sure to:

-Measure the circumference of the vent pipe

-Find a tee fitting that is the correct size

-Locate the vent’s discharge (if applicable)

1. Locate the vent pipe.

2. Measure its circumference.

3. Select a tee fitting that is the correct size.

4. Connect the tee fitting to the vent pipe using plumbers’ tape or clamps.

5. Turn on the gas or water supply to the fixture and check for leaks.

Tips for Plumbing a Vent with a Tee Fitting

If you are installing a new vent with a tee fitting, there are some tips you should follow. This type of fitting is most commonly used when plumbing a vent through the roof.

1. Check your roofing material to make sure it is compatible with the vent installation. Some materials may not allow the use of a tee fitting, and may require a different type of fitting or an alternate method for vent installation.

2. Measure the distance between the roof surface and the vent opening. Use this measurement to create a template for the tee fitting.

3. Cut the template out of cardboard or another suitable material and then cut out the Tee fitment using a sharp knife or saw. Make sure that both edges of the Tee fitment are smooth and round; any irregularities will cause leaks during installation.

4. Place one end of the Tee fitment onto the roof surface and insert it into the vent opening until it touches bottom edge of Vent Opening. Make sure that both ends of the Tee fitment are firmly attached to each other and to the roof surface using construction adhesive or nails (not screws).

5. Install second end of Tee Fitment into Vent Opening so that it extends beyond edge of Vent Opening by 1″ (2.54 cm). Nail or screw second end in place, making sure that it is also firmly attached to both sides of Vent Opening and Roof Surface .


If you’re like most homeowners, you probably don’t have a clue about plumbing a vent. That’s why this article is for you. In this article, we will discuss the different types of vents and how to fit them using a tee fitting. By the end of this guide, you will be able to do it yourself with little difficulty!

Similar Posts

Leave a Reply